What do you get when you combine continental drift and seafloor spreading?
Plate tectonics! In the next two lessons, we will analyze those words. What is a plate? What is tectonics? Then we put it together. Alfred Wegener, who died on the Greenland ice sheet at the age of 50, didn't live to.
What is a Plate?
What portion of Earth makes up the “plates” in plate tectonics? Again, the answer came about in part due to war. In this case, the Cold War. The scientists set up seismometer networks during the 1950s and early 1960s. The purpose was to see if other nations were testing atomic bombs. Since seismometers measure ground shaking, they also recorded earthquakes.
The seismographs located earthquake epicenters. The epicenter is the point on Earth’s surface directly above the place where an earthquake occurs.
When earthquake epicenters are put on a map, they outline the plates. This is because the earth quakes where the plates come into contact with each other. Earthquakes are found primarily in lines around the edges of some continents. They are also found through the centers of some oceans. Some occur in patches in some land areas.
If you look at the map pictured below, you will see that the lithosphere is divided into plates (Figure below). There are a dozen major and several minor plates. Each plate is named for the continent or ocean basin it contains. Some plates are made of all oceanic lithosphere. A few are all continental lithosphere. But most plates are made of a combination of both. Notice the locations where the most earthquake epicenters are found.
A map of earthquake epicenters. The outlines of the lithospheric plates can be seen.
Plates of lithosphere sink into the asthenosphere. The asthenosphere, which is part of the upper mantle, is solid but can flow. If a weight is added to a plate, like a glacier, the plate will sink into the mantle. If the weight is taken away, like when the glacier melts, the plate will rise. This happens slowly over long periods of time.
- epicenter: Point on the Earth's surface directly above the focus of the earthquake.
- plate: Slab of Earth's lithosphere that can move around on the planet's surface.
- seismometer: Equipment that measures seismic waves and other ground motions.
- A plate is a large chunk of lithosphere. There are a dozen major plates and several minor plates.
- A plate can carry continental crust, oceanic crust, or some of each.
- Plates can be identified by the locations of earthquake epicenters.
Use the resource below to answer the questions that follow.
- 100 Greatest Discoveries: Plate Tectonics at http://science.discovery.com/tv-shows/greatest-discoveries/videos/100-greatest-discoveries-plate-tectonics.htm (2:05)
- Which two plates meet in California?
- What occurs where two plates meet?
- What is an ocean ridge?
- What is a strike-slip fault?
- What occurs at strike-slip faults?
- What evidence can be seen in California of the movement of the plates?
- How did scientists draw boundaries around the plates?
- What is a plate?
- What is plate made of?